Turning the alarm system ON or OFF
BeeP
Alarm enabled
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
Enabling the
alarm
Available time:
one minute
Enabling the alarm
When the alarm is enabled:
- the control unit beeps once,
- the indicator light lights up for a few seconds.
If the control unit emits a series of beeps, when the
alarm is enabled or disabled, this means there is a
fault or trouble in the system.
Total system mode on:
this corresponds to the
enablement of all the detectors.
Activation of area 1,2,3 or 4:
this corresponds to the
enablement of the detectors in the area involved.
General information
BeeP
BeeP
Alarm disabled
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
You enter in a
protected room
According to the detectors
you have 45 seconds' time
before the alarm is tripped
Disabling the
alarm
Entering time:
If you are intercepted on entering the surveilled area,
you have 45 seconds in which to disable the system (if
the delayed alarm was configured when the sensor
was installed).
The control unit emits a warning beep during all this
time (if enabled inside the control unit - see page 26).
Exit time:
When the alarm has been enabled, you have one
minute to exit from the surveilled area.
Disabling the alarm
When the alarm is disabled:
- the control unit beeps twice,
- the indicator light lights up for a few seconds.
Use
30