Warning signal test with the control
unit
Press the green control unit’s “Test” push-button.
Every siren emits a brief alarm signal.
The control unit emits a brief alarm signal at the end
of the test.
Control keypad
Press
, then press
.
The control unit BEEPS once.
The dialogue between the control keypad and the
control unit is correct.
INFO
INFO
OK
OK
System test
Detectors
Press the detector’s push-button.
The detector BEEPS once.
The control unit BEEPS once.
The dialogue is correct.
BeeP
BeeP
-
+
OK
INFO
C
-
+
OK
INFO
C
INFO
OK
OK
Remote-control
When the ON or OFF keys of the remote-control are
pressed, this should cause the confirmation signals to
be emitted by the control unit (ON = 1
BEEP; OFF = 2
BEEPS).
AP
EFF
TEST
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
AP
CAN
TEST
2 secs.
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
System sabotage alarm
Alarm memory-stored / In progress
Maintenance Program mode
Alarm ON / Alarm OFF
Close the control unit compartment
When all devices have been installed and verified,
close the control unit compartment.
Attention:
Attention:
To enable the system to operate, the control unit must
be closed.
If the SABOTAGE indicator light flashes, check if all the
system devices are correctly closed.
We advise you to carry out a real test of the system,
activating the alarm system and tripping the alarm itself.
Attention:
Attention:
If the control unit compartment is not already open,
the control unit must be in
MAINTENANCE
PROGRAM mode
.
Warning signal test with the control
keypad
Type in the access code.
Press the configuration access push-button, select the
WARNING SIGNAL TEST
menu and confirm.
Everyone of the system’s warning signal (siren, control
unit) emits a brief beep in succession or an alarm
signal.
27
T
est