7.5
If the Front Mount Bolt breaks.
This piece is designed to break under stress to prevent costly
damage to your operator arm. This piece is easy and cheap to
replace thus saving you the time, money and frustration of ex-
amining the entire arm for damage and possibly replacing an
entire arm. Because this piece is designed to break it is not a
manufacturing flaw when it does and will not be covered by
warranty.
To replace this piece, first remove the six screws on the bottom of
the arm. These are Torax screws, use a Torax screwdriver size T
-
20
to remove the screws.
After the screws are removed and the unit is still lying on its back, lift upward on the bottom
half of the casing. The dust shield, seen below will be attached to both the casing and the front
mount bolt. To remove it from the casing push downward on the ends of the dust shield and it
will snap out of the casing. Then it can slide out from the front mount bolt.
You should now have the bottom off.
1. Lift up on the screw drive shaft.
2. Remove the stainless steel bearing on the end of the screw drive shaft.
3. Spin the front mount bolt until it unscrews off the end. The new one will screw back on
the same way.
Estate Swing
Содержание Estate Swing E-S 1100 Series
Страница 51: ...9 4 Estate Swing...