![background image](http://html1.mh-extra.com/html/faac/estate-swing-e-s-1100-series/estate-swing-e-s-1100-series_instruction-manual_3205477026.webp)
NOTE: Before beginning the one touch learning procedure be sure to have full open and full
closed stop points* set up.
These will let your gate know where to stop during the learning
process. Make sure that the leaf or leaves are in the full closed position against the stop points.
Check your arm to be sure the gate mount pin is 3 turns from the physical end point of the arm
While the 5 function LEDs (A,B,C,D,E in picture) are lit
steadily, briefly press (about 1 second) the
P2
button. [
If P2
is pressed for 3 seconds the opener enters the manual learn-
ing mode
]
The operator or operators start the opening maneuver, and
the function LEDs begin flashing.
Continued on the next page.
6.3
Enter Learning Mode
Enter the programming mode by pressing
P1
6 times until all 5 LEDs (A,B,C,D,E) are lit.
This is the learning mode.
Programming
Press for
1
Second
* Stop points are structures meant to come in contact with and/or stop the gate at the required points.
Wood or metal stakes driven in the ground often make good stop points. For one touch programming
the stop points must stay in after programming. To program without open stop points, use manual pro-
gramming (on next page). Closed stops are always needed.
If using an E
-
S1102 dual operator, both the master and slave arc distance must
be the same to use 1 touch programming. If arcs are different distances then use
the complete learning process found in Section 8.
Estate Swing
Содержание Estate Swing E-S 1100 Series
Страница 51: ...9 4 Estate Swing...