FAAC E024S, Руководство пользователя

Страница: 13 / 18

E024S 13 732642 - Rev. F
1
2
3.9 x 16
11 BUS ENCODER WIRING
10 AUTOMATED SYSTEM TEST
When you have finished programming, check if the system is
operating correctly. In particular, check if the safety devices
are operating correctly.
Fig. 6
9.1 BATTERY KIT OF E024S ON 391 (OPTIONAL)
The battery kit enables you to activate the automated system
even in the event of a mains power fault. The batteries are
housed in a specific compartment inside the operator (see
sequence in fig. 6).
To install, refer to the specific instructions.
The batteries start operating when mains
voltage fails.
E024S is used to control bus encoders. Any encoders connected to the red bus terminal are recognised during bus device
acquisition (chapter 7.2).
The use of this type of encoder offers precise and constant information on leaf position, guaranteeing reverse movement in
case of obstacles.
The encoder is compulsory on hydraulic operators (S450H, S700H, S800H, S800H ENC) and optional on electromechanical
operators.
Leaf 1 Leaf 2 Leaf 1 Leaf 2
Leaf 1 opens as first and closes as second
Leaf 1 (DL1, DL2 on) Leaf 2 (DL1 on)
S450H, 412, 413, 415, 770 , 770N
SAFECODER
Absolute encoder
DL1
DL2
DL3
DL1
DL2
DL3
S700H/S800H
Relative encoder
DL1
DL2 DL3
DL1
DL2 DL3
S800H ENC
Relative encoder
(It only works as a relative
encoder on E024S)
DL1
DL2
DL3
DL1
DL2
DL3
1. Connect the 2 encoder cables to the BUS input (red terminal) on the electronic board.
2. Ensure that the encoder LEDs light up as reported in the table. The LEDs must be checked with the leaf stopped.
Fig. 7
ENGLISH