![background image](http://html1.mh-extra.com/html/faac/b614/b614_manual_3110034036.webp)
B614
34
532297 - Rev.D
6.
START-UP
!
During operation there is a risk of cutting, crushing
or the total loss of hands due to the moving parts
inside the box.
If two barriers are installed in the following config-
uration
Master
-
Slave
, before beginning the start up
of the
Master,
it is necessary to have configured the
Slave
barrier (see the chapter § 9).
1. Check that the B614 manual release is not engaged
so that the arm can't be moved manually.
2. Power up the barrier (
Master
barrier). The board
lights up and the display then comes on:
-
firmware version (2 digits separated by a point)
-
SO
flashing if a set-up or the automation status
is requested
3. Check the status of the LEDs at rest (see the chap-
ter § 10.1).
The BUS 2easy LEDs must be checked after the devices
have been registered.
4. Store the radio transmitter as needed (see the
chapter § 8.2).
5. Program E614 without performing the set-up.
!
For the barrier to work properly, set the parameter
cF
dependent on the arm length.
6. Register the BUS 2easy devices, if they are installed
(see the chapter § 8.3).
7. Check the barrier's direction of travel (see the
chapter § 10.2).
8. Perform the set-up (see the chapter § 6.3).
9. If the Battery Backup is being used:
-
Turn off power
-
Connect the Battery Backup
-
Switch on power to the system.
6.1 PROGRAMMING
BASIC PROGRAMMING
1. Press and hold down
F
until the first basic
function appears. (Each function is displayed
as long as
F
remains pressed).
F
2. Release: the value of the function appears
(default or programmed).
F
3. Use the
+
or
-
button to modify the value.
-
+
4. Press
F
to confirm the value displayed. Go
to the next function. The modified value
becomes effective immediately.
F
Proceed in the same way for all the functions. The last function
(
St
) allows you to close the program.
5. In
St
select
Y
or
no
using the
+
+
/
-
buttons:
Y
= save the new program
no
= DO NOT save the new program
6. Press
F
to confirm and close the program. It returns to the
automation status view.
To
exit from the programming mode at
any time
:
press and hold down
F
and then
-
as well to
move directly to
St
.
F
+
-
Содержание B614
Страница 1: ...B614...