![background image](http://html1.mh-extra.com/html/faac/b614/b614_manual_3110034044.webp)
B614
42
532297 - Rev.D
LC/RC - REMOTE CODE STORING PROCEDURE
Additional radio controls can be stored remotely, i.e.
without having to use the board directly, by using a
radio control that has already been memorised.
1. Near the E614 press buttons P1 and P2 if the radio
control already memorised (as
OPEN
or
CLOSE
at
the same time). The LED of the radio control
and LED DL4 or DL5 of the board begin to flash
for 5 secs.
2. Release both the buttons then press the button
already stored within five seconds. From this
moment E614 stays in the learning phase for
around 20 secs.
3. Make sure that the LED DL4 or DL5 on the board
is still flashing and press the button of the radio
control that you wish to memorise. The LED (DL4
or DL5) on the board goes on as a steady light for
2 sec to then start flashing again for another 20
seconds during which it is possible to store another
radio control.
4. Wait for LED DL4 or DL5 on the board to turn off
before using the new radio control.
DELETING RADIO CONTROLS FROM MEMORY
!
This procedure cannot be reversed and erases ALL the
codes of the radio controls stored both as
OPEN
and
as
CLOSE
. The eresing procedure is only active in the
barrier status display mode.
1. Press and hold down the - button.
-
-
After holding the button down for approx 5 secon-
ds LED DL5 begins to flash slowly, after another 5
seconds flashing slowly and pressure maintained
LEDs DL4 and DL5 begin to flash more quickly
(beginning erase).
-
At the end of the rapid flashing LEDs DL4 and
DL5 come on and remain steady to confirm the
successful erasing of all the (
OPEN
and
CLOSE
)
radio codes in the board.
2. Release the - button. The LEDs turn
off, indicating that the codes were
erased correctly.
-
Содержание B614
Страница 1: ...B614...