PATHWAY HD Code Compliant Modular Access System Installation Manual
Page 64 of 92
5.8.16.
Clamp the handrail standoff to the platform angle post in the corner at 7-3/8”
from the top of the post. Hold a third 1-1/2” diameter 90° elbow such that the
middle of the bend is centered on top of the handrail standoff. Rotate the 90°
elbows attached to the ramp handrails until they are parallel to the ends of the
elbows as needed (FIG. 5.42).
There are two standoffs used at the corner turn post. The handrail standoff
is the larger, longer one of the two.
5.8.17.
Trim all three 1-1/2” diameter 90° elbows until the legs of the elbows align and
there is a 3/4” gap between the legs. Use a ring joiner centered (approximately)
between the legs of the bends to assist in estimating where the cuts should be
and use caution not to trim too much off any one elbow leg (FIG. 5.42).
5.8.18.
Using a metal file, remove any sharp edges from cutting.
FIG. 5.42
Содержание PATHWAY HD Code Compliant Modular Access System
Страница 13: ...PATHWAY HD Code Compliant Modular Access System Installation Manual Page 13 of 92 FIG 2 5 FIG 2 6...
Страница 25: ...PATHWAY HD Code Compliant Modular Access System Installation Manual Page 25 of 92 FIG 4 2 FIG 4 1...
Страница 91: ......
Страница 92: ...Thank you for choosing EZ ACCESS for your accessibility needs www ezaccess com...