Operation
5
- 17 -
1. Setting of the vacuum pump
(1) Open the inspection door for the vacuum pump
(2) Remove the wing bolts fastening the pump mounting base
and the stopper plate of its base.
(3) Pull the pump mounting base out.
The base can be pulled out for 30 cm or so.
(5) Mount the vacuum pump on the pump mounting base.
Make sure that the mounting base of vacuum pump
is inserted into the stopper plate for rear end of the pump.
(4) Remove the wing bolts fastening the pump
and the stopper plate of the front part of the pump.
Applicable types of the vacuum pumps are GLD-136N,
GCD-136XN and GLD-136CN.
Also, when using the pumps other than the aforementioned
types, install the pump outside the FDU main body
and use it.
The vacuum tube can be used by drawing it
from the outlet of the hose container in the back of the main
body.( Refer to the figures on the below.)
In such case, for the vacuum pump, use a different power
source from the main body’s, then cannot drive automatically.
5-1. Preparation for Operation
Rear Face of the Main Body
* To installed the vacuum pump outside the main body,
open the outlet cover for pulling out the hose located
at the rear face of the main body.
And take the vacuum hose in the main body.
Hose Outlet for External Vacuum Pump (with Cover)
Stopper Plate for Rear End of the Pump.
Pump Plate
Pump Fixing Wing Bolt
Vacuum Pump
Mounting Base
Stopper Plate of Front Part of the Pump.
Stopper for
Pump Plate
Pump Fixing
Wing Bolt
Stopper Plate of
Front Part of Pump
Pump Plate
Vacuum Pump Inspection Door
Pump Fixing
Wing Bolt
