Extron electronics XTP T HWP 101 4K, Руководство пользователя

Страница: 13 / 44

XTP T HWP 101 4K Wallplate Transmitter • Installation 5
3. Install the mud ring or metal junction box in the mounting surface (see Mud Ring
Installation on the next page or UL Listed Metal Junction Box Installation on
page 7).
4. Route and connect cables to the rear panel connectors (see Rear Panel Connectors
on page 8).
5. Mount the XTP T HWP 101 4K to the mud ring or metal junction box (see Mounting
the Device on page 9).
6. Connect an HDMI input to the front panel connector (see Front Panel Connectors on
page 10).
7. Supply power to all connected devices.
Metal Junction Box or Mud Ring Installation
Mounting Surface Preparation
1. Using an appropriate template or the mounting enclosure as a guide, use a soft pencil
to mark the area of the wall that will be cut (for the provided mud ring, see
Mounting
Template on page 34).
NOTES:
• If using a junction box, use a UL Listed metal one only.
• Check with the manufacturer of the metal junction box for specific installation
requirements.
• Install junction boxes against wall studs.
2. Use a jigsaw or small hand saw to carefully cut away the material within the guidelines
drawn in step 1.
NOTE:
If using a template or the mud ring as a guide for cutting the hole in drywall,
cut inside the guidelines to maximize the contact between the mud ring and
drywall.
3. If using a mud ring in a wall with insulation inside, remove at least 6 inches of the
insulation in all directions around the cutout.
NOTE: If a wall stud interferes with removing 6 inches of insulation around the
cutout, remove the insulation between the cutout and wall stud.
4. Check the size of the opening by laying the mud ring or metal junction box against it.
The mounting device (mud ring or junction box) should fit snugly in the opening.
5. If needed, use a saw, file, or sandpaper to enlarge the hole.
CAUTION: Risk of personal injury . Smooth the edges of the opening to avoid
personal injury during installation.
ATTENTION :
Risque de blessure
. Lissez les bords de l’ouverture afin d’éviter
toute blessure lors de l’installation.
ATTENTION:
• Smooth the edges of the opening to avoid damage to the mounting device or
the cables.
• Lissez les bords de l’ouverture afin d’éviter d’endommager l’appareil de
montage ou les câbles.