XTP T HWP 101 4K Wallplate Transmitter • Installation
11
Connection Details
HDMI Connection
To secure the HDMI cable to the HDMI connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
3
1
2
3
4
5
Figure 9.
Installing the LockIt Lacing Bracket
1.
Plug the HDMI cable into the panel connection (see figure 9,
1
).
2.
Loosen the HDMI connection mounting screw from the panel (
2
) enough to place the
LockIt over it. The screw does not have to be removed.
3.
Place the LockIt on the screw and against the HDMI connector (
3
), and then tighten
the screw to secure the bracket.
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
4
).
5.
While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap. Remove any excess length (
5
).
ATTENTION:
•
Connect and pull the tie wraps until they are secure. Do not overtighten.
•
Connectez et tirez les serre-câbles jusqu’à ce qu’ils soient sécurisés. Ne pas
trop serrer.
Twisted Pair Cable Termination and Recommendations for XTP
Communication
Use the following pin configurations for twisted pair cables used for XTP communication.
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A
T568B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
TIA/EIA-T568B
Pin
Wire Color
1
White-orange
2
Orange
3
White-green
4
Blue
5
White-blue
6
Green
7
White-brown
8
Brown
Figure 10.
Twisted Pair Cable Termination
Содержание XTP T HWP 101 4K
Страница 6: ......
Страница 8: ...XTP T HWP 101 4K Wallplate Transmitter Contents viii ...