Extron electronics TLP Pro 1220MG, Руководство пользователя

Страница: 30 / 40

Using the Software
GUI Designer
Use the GUI Designer software to design the screen layout for the touchpanel. See the
GUI Designer Help
file for step-by-step instructions and more detailed information.
Global Configurator
Use the Global Configurator software to set up and configure the control processor and the
touchpanel. See the
Global Configurator Help File for step-by-step instructions and more detailed
information. The Global Configurator Help File also includes an introduction to the software and
sections on how to start and configure a project.
Toolbelt
Use the Toolbelt software for device discovery, device information, firmware updates, and
configuration of network settings, system utilities, and user management for TouchLink Pro
devices.
TLP Pro 1220, 1520, and 1720 Series Web Page
To access the touchpanel default web page, enter the IP address of the unit into the web
browser of a PC connected to the same subnet. A dialog opens asking for your user name and
password. By default, the user name is
admin
and the password is
extron
(both user name
and password are all lower case).
• There is a single page, most of which is read-only, providing general and network information
about the unit. Use the
Setup Menu (see page 13) or Toolbelt to configure the
touchpanel network settings.
•
Click Licence Information to see information about Network Port Requirements and
Licensed Third-Party Software Used by the Touchpanels (see page 30).
• Use the
Firmware Uploader
panel to upgrade the unit firmware (see Updating the
Firmware on the following page).
Figure 18 shows the TLP Pro 1520TG web page. The web page for the other touchpanels is
similar.
Figure 18. TLP Pro 1520TG Web Page
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Configuration Software 22