Extron electronics TLP Pro 1220MG, Руководство пользователя

Страница: 20 / 40

I Mounting notches (2) (MG models only) (see figure 3 on page 8) — lower these
notches over the hooks at the top of the mounting frame (see Wall Mounting on page
25).
J
Mounting screws (2) (MG models only) — for securing the bottom of the touchpanel to the
mounting frame (see
Wall Mounting
).
K Rear status light (TG models only) — one LED light bar that can be programmed to
provide system feedback.
•
Light red or green
•
Blink or light continuously
TG models have a status light on both the front and rear panels. Both lights provide
the same information and cannot be programmed individually. For information about
programming this light, see the
Global Configurator Help File .
L
VESA mounting holes (4) — VESA FDMI Type D 100 mm mounting pattern standard used
for VESA mounting (see
VESA Mounting
on page 29).
M Base attachment hinges (2) (TG models only) — Secure the base to the touchpanel. For
VESA Mounting , remove the base by unscrewing the hinges.
Routing Cables (TG Models)
Organize cables behind the rear and base covers for a more esthetically appealing appearance.
The TLP Pro 1520TG is shown below but the TLP Pro 1220TG and TLP Pro 1720TG are similar.
A A
B B
C C
C C
D D
Figure 5.
TLP Pro 1520TG Cable Organization
1. If necessary, remove the rear and base covers and connect the cables as required.
2. Run the cables through the clamp on the back (
A
), and through the restricted gap where
the base and back meet ( B ).
3.
Run the cables through the raceways on either side of the center hole ( C ), and through the
clamp at the back of the base (
D
). Multiple cables, can be loosely bundled to keep them
organized.
4.
Move the cable clamp back into position and press the top to secure it in place
5. Put back the rear and base covers. The base cover must be inserted before the rear cover.
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Panel Features 12