7
Step 8: Mount the EBPs
Prior to mounting:
1.
If it has not already been done, feed all device cables through the wall or furniture and, if applicable, through the plastic spacer.
NOTE:
If the unit is not installed in a mud ring, you must install the plastic spacer. The spacer positions the unit to allow
the magnetic faceplate to attach properly and securely.
2.
Ensure that cables are connected to the EBP rear panel.
Mount the EBP as follows:
1.
Insert the cabled EBP into the mud ring or junction box within the wall or furniture, aligning the mounting holes in the EBP
with those in box or mud ring.
2.
Secure the EBP to the junction box, wall or surface mounting box,
or mud ring as follows (see
1
in figures 7 and 8):
a.
Insert the included screws through the oval slots at
the top and bottom of the EBP, through the
plastic spacer (if not using a mud ring),
and into the corresponding threaded
holes in the box or mud ring.
b.
Using a Phillips screwdriver, lightly
tighten the screws until snug.
Extr
on
DIS
PLA
Y
VOLU
ME
2
2
1
1
EBP 100
Wall Mounting
Bracket
(Mud Ring)
Faceplate
Wall
3.
Attach the faceplate to the EBP: align the faceplate openings with the buttons, knob, and LEDs and place the faceplate
against the unit (see
2
in figures 7 and 8). The magnetic catches fasten the faceplate onto the front of the unit.
3.
Disconnect power at the source from all devices in the system.
Extr
on
DIS
PLA
Y
VOLU
ME
2
2
1
1
Wall
Wall
Box
Faceplate
EBP 100
Plastic Spacer
Figure 7.
Installing the EBP
in a Junction Box
Figure 8.
Installing the EBP
in a Mud Ring
