3
Americans with Disabilities Act (ADA) compliance
When planning where to install these devices, you may need to consider factors affecting accessibility of the button panel such
as height from the floor, distance from obstructions, and how far a user must reach to press the buttons. For guidelines, see
sections 307 (“Protruding Objects”) and 308 (“Reach Ranges”) of the
2010 ADA Standards for Accessible Design
available at
http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf
.
Site preparation
Model
US Gang Size
EBP 100
2
EBP 200
3
Extron offers an assortment of mud rings, optional UL Listed in-wall junction boxes, external wall boxes (EWBs), and surface or
tabletop mounting boxes for use with the eBUS button panels.
Step 3: Change a Faceplate, Button Labels, or Knob
You can replace a faceplate or one or more of the labels within the buttons. Some button labels ship with the unit. You can create
and print your own customized labels using Extron Button Label Generator software.
To change a faceplate or translucent button label:
1.
Remove the faceplate by holding the body of the unit with one hand, gripping
the sides of the faceplate with the other hand, and pulling the faceplate
away from the unit.
2.
Gently separate the button lens button cap from its white diffuser:
insert the end of the provided Extron removal (pry) tool into
the corner notch and gently twist the tool (see
1
in the
image at right).
3.
Remove the label insert from the button cap.
4.
Select one of the button labels from the printed label
sheets included with the unit. Remove the label from its
backing and remove the clear, protective film from the
front of the label.
5.
Insert the button label into the button cap (see
2
at
right).
6.
Align the cap with the white diffuser and the panel
opening, and press the clear cap into place on the button.
7.
Attach the faceplate to the EBP: align the openings of the faceplate with the buttons
and knob and with the LEDs and place the faceplate against the unit. The magnetic
catches fasten the faceplate onto the unit.
To change a knob:
1.
Remove the faceplate as described in step 1 above.
2.
Firmly grasp the knob and pull it away from the EBP.
3.
Align the ridge inside the new knob with the channel on the knob control and allow the magnet in the knob to snap into
place.
4.
Reattach the faceplate to the unit as described in step 7 above.
TEX
T
Separate the
two-piece button
here at the corner.
Diffuser
Base
Insert
button label.
Button
Lens Cap
Removal
(Pry) Tool
1
2
