2
EBP 100/200 Series • Setup Guide (Continued)
Rear Panel Features
PWR LO
AD = 0.5W
PWR LO
AD = 0.5W
ON
123456
BUS ID
M
S
B
L
S
B
ON
12
3456
eBU
S
G
-S
+S
+V
G
-S
+S
+V
EBP 100 Rear Panel
C
C
C
C
D
D
D
D
B
B
B
B
A
A
A
A
Figure 2.
EBP Rear Panel Features
Planning the System and Installation
When planning to install an eBUS system you must consider how many EBP button panels to use, maximum cable distance,
cabling topology, and mounting. See the
EBP 100 and EBP 200 User Guide
for more information about eBUS topologies.
Installation
Step 1: Get Ready
Use the following check list to prepare for the installation.
Download and install the latest version of the software, firmware, and device drivers needed to configure the IPCP Pro and
control the connected AV products. See the
IPCP Pro Series User Guide
(available on the Extron website) for details on
software and drivers.
Obtain network information (IP addresses, passwords, DHCP settings, and the like) and the MAC address for the control
processor.
Obtain model names, drivers, and setup information for AV devices.
Determine which eBUS cabling topologies to use and obtain cables, mounting hardware, and any power supplies or hubs
required by that configuration.
Step 2: Prepare the Installation Site
ATTENTION:
•
Installation and service must be performed by authorized personnel only.
•
L’installation et l’entretien doivent être effectués par le personnel autorisé uniquement.
•
Extron recommends installing the EBP into a grounded, UL Listed electrical junction box.
•
Extron recommande d’installer le EBP dans un boîtier d’encastrement électrique mis à la terre, listé UL.
•
If the EBP will be installed into fine furniture, it is best to hire a licenced, bonded craftsperson to cut the access hole
and perform the physical installation so the surface will not be damaged.
•
S’il est prévu d’installer le EBP dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et qualifié
pour couper le trou d’accès et réaliser l’installation de telle façon que la surface ne soit pas endommagée.
•
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s’appliquent au site de l’installation.
NOTE:
For the installation to meet UL requirements and to comply with National Electrical Code (NEC), the EBP must be
installed in a UL Listed junction box. The end user or installer must furnish the junction box. It is not included with the
EBP 100 or EBP 200.
NOTE:
For rear panel features, all models are identical.
A
Bus ID DIP switches
B
eBUS ports
C
eBUS status LED
D
Maximum power load rating
