DVS 510 Series • Operation
25
Input configuration submenu adjustments
The following table shows how to make the selections and adjustments that are accessed
through the
Input
Configuration
submenus.
Input Configuration Submenu
Horizontal (
[
) and Vertical Knob (
{
) Adjustment
Video Signal Type (Inputs 5, 6, 7, and 9)
Accepted video signal types include RGB, RGBcvS,
YUVp/HDTV, and YUVi.
Select the desired video format for the selected input.
The default is
RGB
.
Film Mode Detect
Enable and disable 3:2 pulldown detection for NTSC
and 2:2 film detection for PAL video sources.
3:2 and 2:2 pulldown (film modes) help maximize image
detail and sharpness for video sources that originated
from film. When film is converted to NTSC video, the
film frame rate must be matched to the video frame
rate. “Jaggies” and other image artifacts can result
if conventional deinterlacing techniques are used on
film-source video.
When film mode is enabled, the DVS recognizes
signals that originated from film and then applies video
processing algorithms that optimize the conversion
of video that was made with the 3:2 or 2:2 pulldown
process. This results in sharply detailed images.
Select
On
or
Off
to turn 3:2 or 2:2 pulldown (film mode)
detection on and off for the selected input. The default is
Off
.
Vertical Start Position
The distance in pixels from the top edge of the total
video display area for the selected input to the top edge
of its active area
Select the vertical start position. The default is
128
.
Horizontal Start Position
The distance in pixels from the left edge of the total
video display area for the selected input to the left edge
of its active area
Select the horizontal start position. The default is
128
.
Pixel Phase (Inputs 5, 6, 7, and 9)
The point at which pixels are sampled (available only for
RGB and YUVp/HDTV inputs)
Select the amount to move the pixel sampling point to
ensure output clarity. The range of settings is
0
through
31
. The default is
16
.
Total Pixels (Inputs 5, 6, 7, and 9)
The width in pixels of the total video display area
(available only for RGB and YUVp/HDTV inputs)
Select the width in pixels of the total video display area
for the selected input. The default width is marked with
an asterisk (
*
) on the LCD screen.
Active Pixels
The width in pixels of the active video area
Select the width in pixels of the active video area for
the selected input. The default width is marked with an
asterisk (
*
) on the LCD screen.
Active Lines
The height in lines of the active video area
Select the height in lines of the active video area of the
selected input. The default width is marked with an
asterisk (
*
) on the LCD screen.
