Extreme Networks EAS 100-24t Switch, Руководство по установке оборудования

Страница: 19 / 40

Mounting the Switch in a Standard 19" Rack
Extreme Networks EAS 100-24t Switch Hardware Installation Manual
19
Mounting the Switch in a Standard 19" Rack
WARNING!
Installing systems in a rack without the front and side stabilizers installed could cause the rack to tip over,
potentially resulting in bodily injury under certain circumstances. Therefore, always install the stabilizers before
installing components in the rack. After installing components in a rack, do not pull more than one component out of
the rack on its slide assemblies at one time. The weight of more than one extended component could cause the
rack to tip over and may result in injury.
Figure 9: Installing Switch in a rack
Power on AC Power
Plug one end of the AC power cord into the power connector of the switch and the other end into the
local power source outlet.
Power Failure
For AC power supply units, as a precaution, in the event of a power failure, unplug the switch. When
power has resumed, plug the switch back in.
WARNING!
Installing systems in a rack without the front and side stabilizers installed could cause the rack to tip over,
potentially resulting in bodily injury under certain circumstances. Therefore, always install the stabilizers before
installing components in the rack. After installing components in a rack, do not pull more than one component out of
the rack on its slide assemblies at one time. The weight of more than one extended component could cause the
rack to tip over and may result in injury.