Extreme Networks EAS 100-24t Switch, Руководство по установке оборудования

Страница: 28 / 40

Chapter 4: Introduction to Switch Management
Extreme Networks EAS 100-24t Switch Hardware Installation Manual
28
Figure 15: Show switch command
The switch's MAC address can also be found from the Web management program on the System
Information window in the Configuration folder.
The IP address for the switch must be set before it can be managed with the Web-based manager. The
switch IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual
address assigned to the switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as
follows:
Starting at the command line prompt, enter the commands
config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy
Where the x's represent the IP address to be assigned to the IP interface named System and the y's
represent the corresponding subnet mask.
Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z . Where the x's represent the
IP address to be assigned to the IP interface named System and the z represents the corresponding
number of subnets in CIDR notation.
The IP interface named System on the switch can be assigned an IP address and subnet mask, and then
be used to connect a management station to the switch's Telnet or Web-based management agent.
EAS 100-24t:4#show switch
Command: show switch
Device Type : EAS 100-24t Gigabit Ethernet Switch
MAC Address : 00-04-96-52-83-9C
IP Address : 0.0.0.0 (Manual)
VLAN Name : default
Subnet Mask : 0.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.00.002
Firmware Version : Build 1.00.002
Hardware Version : A
Serial Number : ABCDE-10002
System Name :
System Location :
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
802.1X : Disabled
Telnet : Enabled (TCP 23)
Web : Enabled (TCP 80)
RMON : Disabled
SSH : Disabled
SSL : Disabled
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All