Extraflame EcoLogica Idro, Инструкция по эксплуатации

Страница: 21 / 40

Page 21
11. ROOM THERMOSTAT
11.1
Digital thermostat (standard)
The stove can control the room temperature by means of a digital thermostat whose function is to
lower the heating power to the minimum when a pre-set temperature is reached.
1. When the stove has been started and has entered normal operating mode, a number
(e.g. 21°C ) appears on display
D1 indicating the room temperature .
2. The thermostat can be set using button 2 or 3 . A message appears on the display
which alternates the word “Set” with the temperature set each time one of the buttons
is pressed. Pressing 2 decreases the value and pressing 3 increases it.
3. Wait until the message “Set” disappears from the display.
4. Use buttons 4 and 5 to adjust the heat setting as desired.
When the appliance reaches the set temperature, it automatically goes to the minimum operating
condition and LED 1 on display
D1 goes off.
If you wish to exclude the digital thermostat, use button 3 to set the temperature to the maximum
until “ HOT ” appears on display D1 .
The same functions can be obtained by remote control.
11.2
Mechanical thermostat (optional)
N.B.: Installation must be carried out by an authorised technician.
A thermostat can be placed in a room adjacent to the one in which the stove is installed. Just
connect a mechanical thermostat (like those used for boilers) following the procedure described
below. (We recommend positioning the optional thermostat at a height of 1.50 m above floor
level.)
11.2.1
Installing a mechanical thermostat (optional)
N.B.: Installation must be carried out by an authorised technician.
1. Switch off the appliance using the master switch on the back of the stove.
2. Disconnect the plug from the socket.
3. Referring to the electrical wiring diagram, connect the two thermostat wires to the
respective terminals on the back side of the stove, one red and one black
11.2.2
Mechanical thermostat operation
1. Light the stove using button 1 .
2. Set the desired heating power using buttons 4 and 5 .
3. Bring the room temperature to minimum using button 2 ; the display will show “Lou ”.
4. Set the desired room temperature on the thermostat (e.g. 21C°); the display will show “t
on” .
5. When the stove reaches the desired temperature, it goes to the minimum operating
condition (
“Lou” appears on D1 ). If the temperature drops, the stove will pass to “ t on”
again, returning to the setting previously made.