Extraflame EcoLogica Idro, Инструкция по эксплуатации

Страница: 28 / 40

Page 28
12.4
Pellet loading adjustment
If the stove has operating problems due to the quantity of pellets, you can adjust the pellet load
directly from the control panel.
Problems related to the quantity of pellets fall into one of two categories:
1
- LACK OF PELLETS
•
The stove cannot develop a suitable flame, tending to burn very poorly even at high
speeds.
•
At the lowest speed, the stove tends to almost burn out, causing the stove to go into “ NO
PELL ” alarm status.
•
When “ NO PELL ” is displayed, there may still be some unburned pellets in the brazier.
2 - EXCESS PELLETS
•
The stove develops a very high flame even at low speeds.
•
The flame tends to soil the stove window, darkening it almost completely.
•
The brazier tends to get incrusted, blocking the air intake holes, due to the excessive pellet
load that is only partially burned.
N.B.: If this problem occurs just a few months after installation, check to make sure that the user
is correctly carrying out the regular cleaning schedule described in the instruction manual.
The adjustment is made on a percentage basis, and therefore any change of this parameter leads
to a proportional variation on all loading speeds of the stove.
To access the percentage adjustment of pellet feeding, you have to enter the user programming
by pressing button
3 , and while keeping it pressed, press button 5 .
At this point use button
5 to move through the menu until you see “F” flashing on D2.
If you go beyond this parameter unintentionally, exit by pressing button 1 and repeat the
procedure.
The value
“00” will be shown on D1 : using buttons 2 and 3 , you can set an increased/decreased
percentage at 5 point intervals (the parameter can be modified with a maximum scale from -50 to
+50).
Adjustment table
LACK OF
PELLETS
Increase the percentage by 5 percent and try the stove with this new setting
for at least half an hour. If the problem is reduced but not resolved, increase
by a further 5 percent. Repeat this process until the problem is resolved.
If the problem cannot be resolved, contact the service centre.
EXCESS
PELLETS
Decrease the value by 5 percent and try the stove with this new setting for at
least half an hour. If the problem is reduced but not resolved, decrease by a
further 5 percent. Repeat this process until the problem is resolved.
If the problem cannot be resolved, contact the service centre.
When the final adjustment has been made, press button 1 to confirm and exit the program.