Extraflame DUCHESSA IDRO, Руководство пользователя

Страница: 27 / 48

PRODUCT FUNCTIONALITY
27
Chapter 7
BASIC INSTRUCTIONS
The stove you have purchased uses pellet fuel. This type of material is obtained from natural waste from
the machining of wood.
By means of a special process that does not
require the use of any binding agent and additive, the waste is compressed in industrial machinery under
high pressure and they become solid wooden pellets.
IT IS PROHIBITED TO BURN NON-PELLETISED RAW MATERIALS INSIDE OUR STOVES. THE FAILURE
TO COMPLY WITH THESE PRESCRIPTIONS VOIDS ALL GUARANTEES AND COULD JEOPARDISE THE
SAFETY OF THE APPLIANCE.
The following recommendations must be followed the fi rst two or three times the stove is ignited:
no children must be present because the vapours emitted can be noxious to health. Adults should
™
also avoid long stays.
Do not touch the surfaces as they could still be unstable.
™
Air the room well several times.
™
The hardening of the surfaces is terminated after several heating processes.
™
This appliance must not be used to burn waste.
™
IGNITION
Before switching the stove on the following points must be verifi ed: 6.
a. the feed-box must be full of pellets
b. the combustion chamber must be clean
c. the pot must be completely free and clean
d. check the hermetic closure of the fi re door and the ash drawer
e. make sure the power supply cable is connected correctly
f. the bipolar switch in the rear right part must be positioned on 1
Press button 1 for 3 seconds: display D1 will show 7. “AT 08” decreasing by one number every second.
In the phase the appliance performs self-analysis to check the functionality of each individual electric
component. When this cycle has been completed, display D1 will show
“AC 15” (these are the minutes
when the stove attempts the ignition phase and decreases by 1 every minute that passes).
NOTE: The fi rst time the product is used, even if the feed-box is full, there is the possibility that the pellets
are not distributed into the combustion chamber for the fi rst 15 minutes. This is because the pellet feed
worm screw is empty. If no fl ame has developed in the stove after 15 minutes D1 will show
“NO ACC” .
If points 1 and 2 have been performed correctly, when the fl ame is developed the stove will pass to 8.
start mode (
“AU 07” ).
On termination of the start phase the stove will pass to normal functioning. 9.
ATTENTION!!
1. DO NOT USE ANY INFLAMMABLE LIQUIDS FOR IGNITION
2. DO NOT ALLOW THE BAG OF PELLETS TO COME INTO CONTACT WITH THE BOILING HOT STOVE
DURING THE FILLING PHASE
N.B. In the case of continuous ignition failure, contact an authorised technician