Hermiankatu 6–8, 33720 Tampere | +358 10 773 5400 | [email protected] |
MANUAL
9.
Annual test duration
Choose annual test duration, 1h or 3h.
10. Area monitoring
Control area monitors connected to the system.
11. Current measuring
12. GND Leakage Set Up
Not valid in ESC-200P system.
13. Change language
Here you can set the operating language to be English, Swedish or Finnish.
14. Read address from PC
Appliance IDs can also be read form the PC.
15. Stop / Allow communication errors
Normally these communication errors are stopped.
The center checks if there is some communication errors with appliance IDs
16. Browse appliances
Here you can check all the appliances connected to the center.
First you have to choose Loop 1 or Loop 2 by pushing “SET” and then you can browse appliances
by pushing “UP” or “DOWN”.
17. Inverter use
This is supposed to be switched ON when using ESC-200P system with central battery.
18. Print appliance ID
19. Event Log
You can connect your PC with the ESC-200P and print out the events via Ethernet converter.
20. Remove appliance
When removing appliance from Loop 1 or Loop 2 you also have to remove that appliance from the
appliance list.
