21
Removable Bar (CXS 280 Only)
Adding the Bar
1. Hold the Slide Bumpers in one hand where you can see the Bar Latch.
2. Reach your fingers up through the Latch Hole and turn the Bar Latch Dial
counter clockwise until it falls against the edge of the Slide.
3. Turn the Bar Latch Dial counter clockwise until the Latch Lock is fully exposed.
4. While holding the Rear, align the Latch Hook with the Latch Lock Receiver on
the Bar with the Slide Bumpers sitting in the Slide Bump Receivers and firmly
pressing against the Bar Pins.
5. Once aligned, turn the Latch Hook clockwise until locked. Flip up the Bar Latch
Dial to lock into place.
Removing the Bar
1. Hold the Rear and Bar in one hand and flip the Bar Latch Dial down into a
middle position.
2. Turn counter clockwise until the Latch Lock disengages from the Latch Lock
Receiver and disconnect by pulling the Bar back and then down until the Bar is
removed.
3. Turn the Bar Latch dial clockwise until the Latch Lock is fully raised.
4. Reach through the Latch Hole and push the Bar Latch up until firmly in place.
5. While holing the Bar Latch up through the Latch Hole, turn the Bar Latch dial a
half turn clockwise to store the Bar Latch while not in use.
