14
*WARNING! Do not stand or place body weight on Excy unless the pin is fully removed
and Excy is placed in its lowest position with the Slide pushed in (weight limit 220 lbs.).
Setting Height Adjustments
The Clevis is used in coordination with the Locking Holes to secure preferred workout
positions.
1.
To remove the Adjustment Pin, release the spring part from around the end
and rotate it to other side of the pin where it is attached. Grab the free end of
the spring and pull the pin out while twisting back and forth.
2.
Align the Locking Holes to your preferred height by pivoting the Rear up or
down. Note that when the Slide and Bar on installed, you may find it easier to
set those on the ground and hold onto and rotate the Front when choosing
and aligning the holes.
3.
Once the Lock Holes are aligned with the Clevis Pin Holes, insert the
Adjustment Pin through the Locking Holes and push it through the Clevis Pin
Holes. This might require a little wiggling and force the first few times. Hold
onto the loose end of the Clevis Spring to make it easier to insert while
twisting a little back and forth. Once the head of the pin is in contact with the
side of the Rear, rotate the Clevis Spring to the other side and clip it over the
end of the pin.
