28
9.2 Accessories
Turn the machine OFF and remove the plug from the wall outlet before you install/adjust
accessories.
9.2.1 Liquid suction nozzle
• Install the container installation for the adjustment unit.
• Put the suction nozzle in the container installation.
• Attach the suction hose to the WD 72-2 dust and water extractor.
Never suck up hot and flammable liquids, this is dangerous!
9.2.2 Shrub tank
• Install the shrub tank to the handle.
• Put the hose on the connection of the pad holder.
• Fill the tank with cleaning agent.
• Set the dosage.
Carefully read 9.2.3!
9.2.3 Use of cleaning agents
When you use cleaning agents, pay special attention to the use instructions mentioned on the
labels. Use only low-foam cleaning agents that do not have any combustible components
added to it and raw materials that can pose a health risk. Also, the use of cleaning products that
contain toxic, irritating or skin-damaging substances are subject to hazards. Cleaning agents
which contain solvents that can corrode plastics, can also damage parts of the machine.
9.3 Lets go!
• Roll the machine to the place where it is going to be used.
• Check the ON/OFF switch is switched OFF.
• Insert the extension cable in the machine plug and in a properly grounded wall socket.
• Tilt the machine on its handle and wheels for easy mounting of the accessories.
• Turn the machine in upright position: on the wheels and the pad.
• Push with your foot on the locking pin for adjusting the T-handle back into the working
position. Release the locking pin in a slot to fix the position.
• Power switch ON: the motor starts and the pad starts working.
• During work the machine can moved in all directions easily and with little force. Work in long
tracks up and down, not in short back-and-forth-going movements.
• If your machine is equipped with a liquid tank, supply extra water by lifting the lever.
• Always turn the machine OFF immediately when you quit working, else the floor can be
damaged. Take the plug out of the socket.
