27
EXCENTR 55-35
7. STORAGE
The following actions are recommended if the machine has not been used for an extended
period of time:
TAKE NOTE!
Always be careful with bearings when using a sprayer/blower to clean the machine!
• Clean the machine with a damp cloth.
• Perform maintenance.
• Possibly apply a preservative.
• Store the machine in a dry and frost-free location.
8. TRANSPORT
First remove all installed ballast plates. The basic machine weighs approximately 45 kg and
must be lifted by two persons. The machine must be transported in upright position, preferably
with the handle in the top-most position:
• Use your foot to push the locking pin out of the recess at the bottom of the handle;
• Adjust the handle - with locking pin pressed - to the top-most position;
• Release the locking pin so it falls in the last recess.
TAKE NOTE!
When transporting on a always secure the machine by attaching lashing straps.
9. USE
9.1 Checks before you start
You are working with (scrub) water and a 220 V machine. Make sure that:
• The mains voltage is 220 V
• The earth connection functions properly
• A GFCI (Ground Fault Circuit Interruptor) is installed.
- Check the cables for damage: both the short power cable as well as the extension cord! If you
detect any deviations: solve these first before you start to work!
- Before starting treatment with the Excentr 55-35, examine the floor on colour and shape
retention.
- Before you start, check if the correct pad for the job is attached.
- Check that at least one set of weights is installed, but no more than six sets!
- The number of weights on the left and right-hand side of the motor must be equal!
EN
