eXact PipeCut 170, Руководство по эксплуатации

Страница: 17 / 22

17
Operation
english
Exact PipeCut 170 Bat-
tery pipecutting system
operating instructions
Before operating the tool
Ensure that the motor unit is in the upright
position. The yellow mark of the UNLOCK button
is visible.
Check that the blade is correctly fi tted, in good
condition and suitable for the material to be cut.
Ensure the pipe saw guide wheels rotate.
Ensure the support wheels rotate.
Check the operation of the lower blade guard.
Ensure the pipe is empty.
If plastic pipes have been cut with the pipe saw
(resulting in long, statically charger slivers), open
the blade guard cover, and clean carefully the
lower blade guard and the entire pipe saw.
Mounting the battery
Put a fully loaded battery to the battery rails of
the saw. Push it to the end so that it is properly
connected. Check that the battery is correctly
in its place by pushing the battery indicators
button (Figure A/2) . If the battery is correctly
mounted and fully charged all the led lights
should light up. If the battery has been used
the number of led lights indicates the charging
level of the battery. To take the battery off from
the saw, push the battery release buttons (A/3)
simultaneously on both sides of the battery and
pull the battery along the rails off from the saw.
Fig B
Fig C
Cutting mark
Cutting point
20 mm
Precise setting of the cutting point
When you mark the cutting point on the pipe to
be cut, deduct 20 mm inch from the required
dimension (Easy-to-remember rule: The cutting
mark location requires a measurement of -
20 mm.) (Figure C)
Setting the pipe on supports
Use the system supports when cutting pipes.
This will ensure safe working and optimum
result. Work on fl at surface. Place the pipe on
two supports so that the cutting point is between
the supports. Place two more support under both
ends of the pipe. Check that all support wheel
contact the pipe (adjust if required e.g. with
pieces of lumber) (Figure B) .
When cutting short pipes (25 cm or less) place
the supports so that the cutting point is outside
supports (Figure D) . Support the pipe with your
left leg, if required. Proper arrangements will
prevent the blade from jamming as the pipe is
cut through.
Fig D