eXact PipeCut 170, Руководство по эксплуатации

Страница: 14 / 22

14
Charging Battery Pack
Instructions
1. Make sure power circuit voltage is the same
as that shown on the charger speci fi cation
plate. Connect charger to power source. Red
light (2) should light up. This indicates the
charger is ready to begin charging.
2. Position a battery pack (6) on charger (3);
align rails on battery compartment (5). Slide
battery forward onto charger until it stops.
3. And the red light (2) will go out and green
light (1) begins to blink continuously,
indicating that the battery pack is receiving
a “Fast Charge”.
4. After approximately 60 minutes the battery
pack is fully charged. The green light will
become steady.
5. Disconnect the battery pack and the charger
in turn (unless you would like to charge
another battery pack, or to leave the battery
pack on Trickle-Charge mode until you are
ready to use it.)
Charger Operation
english
Exact
Li-ion 18V Battery Charger DC18EU-02
Operating instructions
Charger LED light indicator
Intelligent Battery
Charger with Air Forced
Cooling System
Stand by
Charging
Ready / Charged
Temperature high or low
Defective battery
GREEN RED
GREEN RED SITUATION
1. No Light Steady Light Standing by (when no battery pack is inserted)
2. Blinking Light No Light Charging
3. Steady Light No Light Charging is complete = Charged = Ready
4. Blinking Light Blinking Light Battery pack is too hot or too cold (charging will begin
automatically when battery reaches correct charging temperature)
5. No Light Blinking Light Damaged or faulty battery pack