Design and function
MIG/MAG welding
70
099-005231-EW501
10.05.2012
Setting the correction range:
• Switch on the "Correction operation" special parameter (P7=1) and save the setting.
(See chapter entitled "Selecting, changing and saving parameters".)
• Key switch to position "1".
• Set correction range according to the following table:
Display (examples)
Operating
element
Action Result
Left Right
Press button until "PROG" LED comes
on.
Left:
Wire feed speed
VOLT
PROG
x
n
Right: Program
number
Press button and hold down for approx.
4 s
Left:
Current limit value of the wire
feed speed correction
VOLT
PROG
4 s
Right:
Current limit value of the
voltage correction
m/min
Set limit value for the wire feed speed
correction
Set limit value for voltage correction
After approx. 5 s without further user intervention, the set values are
adopted and the display switches back to the program display,
• Key switch back to position "0"!
Switching programs with the standard torch trigger (P8)
Special latched (latched absolute program sequence)
• Cycle 1: absolute program 1 is run
• Cycle 2: absolute program 2 is run after completion of "tstart".
• Cycle 3: absolute program 3 is run until the "t3" time has elapsed. The program then switches
automatically to absolute program 4.
Accessory components such as remote controls or special torches may not be connected!
Figure 5-37
Содержание Taurus 401 Synergic FKG
Страница 6: ...Contents Notes on the use of these operating instructions 6 099 005231 EW501 10 05 2012...
Страница 20: ...Machine description quick overview Rear view 20 099 005231 EW501 10 05 2012 4 2 Rear view Figure 4 2...
Страница 37: ...Design and function MIG MAG welding 099 005231 EW501 10 05 2012 37...
Страница 100: ...Appendix B Overview of EWM branches 100 099 005231 EW501 10 05 2012 12 Appendix B 12 1 Overview of EWM branches...