16
Telesm a r t T XG
6.3 Installation
• Execution by qualified personnel
WARNING
Risk of injury and material damage due to manipulation of the
screws on the device
Manipulation or loosening of the screws on the device or on the
options may lead to injuries and material damage during the
operation.
Therefore:
• Never loosen screws on the device or the options.
Please pay attention to the installation instructions which are
delievered with the device.
The TXG can be secured to either Ewellix mounting plates
(⮑ 4.6 Accessories, page 12) or the customer’s own
plates. Plastic base plates are fitted to the end faces of the
outer and inner tubes. The mounting plates are secured to
the aluminium tubes by means of four bores in each of the
base plates. When the screws are screwed in, a thread is
formed in the prepressed holes in the aluminium tube. The
outer tube is screw-connected using the outer bores (⮑ fig.
4
),
while the inner tube is screw-connected by means of the in-
ner bores (⮑ fig. 5).
Fig. 4
4 x M6x40 DIN7500
(9-11 Nm)
4 x M6x40 DIN7500
(9-11 Nm)
Fig. 5
4 x M6x40 DIN7500
(9-11 Nm)
4 x M6x40 DIN7500
(9-11 Nm)
Any subsequent fastening bores in the aluminium tubes may
only be made by Ewellix. The sides of the inner tubes must
not be scratched, otherwise the tube guide will be damaged.
This can result in malfunctions.
CAUTION
Only use the screws supplied (M6 x 40 DIN 7500).
Ensure that the screws are inserted to a minimum depth of
25 mm and that the torque is 9 to 11 Nm.
CAUTION
Do not form a thread into the bores with a thread tap.
The actuator may be damaged.
CAUTION
When using your own mounting plates, ensure that the base
plates are supported over their full area.
The base plates may be damged.
WARNING
Risk of injury and material damage!
Pay particular attention to avoid anything may be squeezed
between the base plates of the inner and the outer tube.
WARNING
Risk of injury and material damage!
Ensure that metal mounting plates are not grounded using the TXG.
They must be grounded or insulated by the customer if required.
In case of using additional equipment which has not protection
class II, the mounting plate must be connected to the earth wire.
