Evoqua DEPOLOX, Инструкция по эксплуатации

Страница: 44 / 104

5. Installation DEPOLOX® 400 M
44
EN
5.10.2 Removing and replacing the
transport plug
DEPOLOX® 5 C non-pressurized version
1 Remove the yellow protection plug from
the electrolyte storage tank.
2 Replace the transport plug with the stop-
per provided.
Fig. 7 Section, cell body cover
A Protection plug (yellow)
B
Stopper (with white venting rod)
DEPOLOX® 5 C pressurized version
1 Unscrew the knurled nut.
2 Remove the long transport plug (A) from
the electrolyte storage tank
3 Replace it with the short stopper (B) pro-
vided.
4 Screw on the knurled nut.
Fig. 8 Section, cell body cover
A Transport plug (long)
B Stopper (short)
C K nurled nut
5.10.3 Add electrode cleaning sand
The electrode cleaning sand (W3T158743) is
supplied in a plastic bottle. The cap serves as
a measure.
1 Close the ball valve on the sample water
inlet.
2 Close the ball valve on the sample water
outlet on the pressurized version.
3 On the non-pressurized version, remove a
sealing plug or sensor from the cell body
cover.
4 On the pressurized version, remove the
protection plug or sensor from the cell
body cover.
5 Fill the cleaning sand cap (plastic bottle)
up to one-third and pour the cleaning
sand into the cell body via the location
hole of a sensor (approx. 0.01 fluid ounce
(approx. 1/3 cm³) of cleaning sand).
Fig. 9 Cutaway model, plastic bottle
NOTICE
Before commissioning the DEPOLOX® 5 C
flow cell, the transport plug must be remo-
ved from the electrolyte storage tank and
replaced with the stopper provided.
ATTENTION
During operation, always use the protection
plug.
A
B
A
B
C