32
01-2019 5505 00
t
wo
-
motor
sElEctioNs
To dispense long products, you can mount
the dividers in order to use two motors for
one single selection.
Use this function to combine the operation
of two motors by specifying the selection
number and the second motor.
The first motor number will be the selection
number whereas the selection number of
the associated motor will remain disabled.
Important !!!
After a failure to the motors of these se-
lections, follow the procedure intended
to configure the “Spirals/Selections”
menu of the machine.
p
HotocEll
paramEtErs
The machine can be fitted (as a standard or
as an option according to the models) with
a device intended to detect the passage
of dispensed products by means of photo-
cells.
If no dispensing cycle is detected for a
product, this device will enable you to:
-set a rotation time for the spiral beyond the
limit switch, to overcome any jam;
-return the paid amount or not;
-lock any further selection on the spiral in
question.
TEST
This group of functions is intended to test
the main components of the machine.
t
Est
sElEctioN
Use this function to simulate the normal
dispensing mode of products without in-
serting the amount to check the operation
of the spiral rotation by pressing the selec-
tion buttons.
m
otor
tEst
It is intended to operate all motors in se-
quence and to display the selection number
in question.
a
utotEst
A function is implemented in the software
to check the correct operation of some de-
vices half-automatically.
Some checks occur automatically, others
require the manual operation of the compo-
nent under check.
The following devices are controlled:
-Temperature: To display the temperature
value measured by the probe.
In case of interruption of the electric con-
nection of the probe, -11.0 will appear
In case of a short-circuit of the probe, 41.0
will appear.
-Buzzer: A series of sounds is produced to
check the operation of the acoustic signal-
ler.
-Compressor: Press
and
to activate
and deactivate the compressor.
-Selections: To activate all selections in a
sequence.
-Coin mechanisms: to make sure that the
communication with the coin mechanism
is properly working and to check which
validator lines are set up as active.
