Assembly and Maintenance
NPC-8210
- 35 -
5.5.2 Removing the Power Supply
Danger!
Before removing the power module, if power is connected, it must be turned off and
cable unplugged.
The steps to remove power supplies of
NPC-8210 equipped with single and redundant
power supply
are the same: first open the chassis cover, remove the fan shield, loosen
the screws fixing the power bracket, power supply and tail end of power supply, and
pull out the power cable terminal, then you can take out the power supply from the
chassis.
5.6 Installation and Removal of Fan
5.6.1 Installing the Fan
NPC-8210 adopt externally rawable fans, and the cables can be inserted or pulled out
outside the chassis. Reach your fingers into the fan hole to insert the fan terminal
outside the chassis, push the fan module into the fan hole, then tighten the two M3
countersunk head screws on the fan panel, as shown in the figure below:
