EVO Manufacturing EVO-3010, Инструкция по эксплуатации

Страница: 12 / 22

12
20.
After center pilot hole is drilled on driver
side through both sides of frame DRILL
INSIDE HOLE ONLY with 5/8” drill
21.
On outside of frame we need to make a
relief hole to install nut and washer
inside frame to newer lower control
arm
bolt. Using at 1” or larger hole saw
and the previously drilled pilot hole
make hole in OUTSIDE of frame ONLY.
22.
On rear, we need to trim some of the rear
body mount bracket on frame just rearward
of the body mount itself on
driver/passenger sides. Use the EVO Long
arm as a template and slowly trim and fit
body mount bracket until bracket fits nicely
against body mount bracket and lower hole
on underside of frame line up to install bolt.
Roughly the rear side of the body mount
will need to be full trimmed and cleaned to
frame ~1/2” rearward of body mount small
bolt.