EVO Manufacturing EVO-3010, Инструкция по эксплуатации

Страница: 11 / 22

11
17.
At exhaust collector, remove bolt on
frame side of the collector and re-
install opposite way (from front to
back) through existing exhaust
flange nut, tighten to snug. On rear
side install supplied M8 nut.
18. Once all control arm mounts are
clearance clean to frame. Starting in
the front install front driver long arm
bracket to frame using the single
bolt hole on the underside of the
frame, where exhaust bar was once
bolted, using original factory bolt.
This will locate this bracket in the
proper location. Slight clearance of
edge/lip on exhaust collector may be
required. Do so as needed.
Repeat previous step on passenger side
(less exhaust note)
19.
On driver side front only, lower arm
mounting hole will need to be drilled
through frame. Mark center using
bracket as template and drill through
both sides frame using a drill similar
in size to your hole saw centering
drill bit (~1/4” drill). Bracket may
need to be removed to drill. Be
careful to keep drill as square and
centered while drilling outer frame
material.