Evinrude E-TEC 115, Оригинальное руководство пользователя

Страница: 39 / 90

37

E
NGINE
M
ONITORING
S.A.F.E . – SPEED ADJUSTING FAILSAFE ELECTRONICS
If the EMM senses a problem could cause permanent engine damage, it will limit engine speed
to 1200 RPM. This additional protection feature is referred to as S.A.F.E. (Speed Adjusting
Failsafe Electronics). If the engine was running faster than 1200 RPM when the S.A.F.E . mode
activated, it will shake noticeably. Under certain operating conditions the EMM will shut OFF
the engine.
The following warnings may appear on the engine monitor gauge.
“LOW OIL”
“NO OIL”
Your outboard is designed to run in “get home” mode for up to five hours in the event you run out
of oil. Refill the oil tank. Prime oil system. Refer to
Priming the Oil System
on page 19.
“WATER TEMP” or “HOT”
“CHECK ENGINE” or “CHK ENG”
A
WARNING
In the S.A.F.E. mode, engine speed is limited. Under certain conditions, the engine’s limited
speed may reduce maneuverability of your boat. If the S.A.F.E. mode is activated and you are
unable to correct the problem, seek assistance and/or return to safe harbor. Serious engine
damage, engine shutoff, and/or reduced maneuverability may be imminent.
Symptom Oil in the oil tank is at reserve level (about 1/4 full)
Result
EMM will activate low oil light or display warning
Action
• Fill the oil tank with recommended outboard oil as soon as possible to avoid emptying the
tank. The outboard has a limited amount of normal running time before “NO OIL” condition
occurs. Refer to
Filling the Oil Tank
on page 19. Always refill the oil tank with recom-
mended oil as soon as possible.
Symptom There is an oil delivery problem
Result
EMM will activate S.A.F.E.* mode
Action
• If the oil tank is empty, add the recommended oil.
• If the oil tank is not empty, seek assistance and/or return to safe harbor.
Symptom The engine is overheating
Result
EMM will activate S.A.F.E.* mode
Action
• A continuous light with S.A.F.E. mode — The EMM has identified an overheating condi-
tion. Check the water pump indicator for a steady stream of water. Shut OFF the engine.
Clear the water intake screens of any debris. If the overheat condition still exists, the en-
gine will operate in “get home” mode. Return to harbor immediately.
• A flashing light — The EMM has identified a damaging overheating condition. The engine
will not operate. Allow the engine to cool for 20 minutes and return to harbor immediately.
See your Dealer.
Symptom An abnormal operating condition
Result EMM will activate check engine light or display warning
Action
• A flashing light — The EMM has identified an abnormal operating condition related to
the fuel system. The engine will shut OFF and cannot be restarted.
• A continuous light with S.A.F.E. mode — The EMM has identified a problem with the
outboard. Seek assistance and/or return to harbor. See your Dealer.
• A continuous light without S.A.F.E. mode — The EMM has identified a problem that
should be addressed by your Dealer as soon as practical to avoid operational difficulties.
A
WARNING
If the outboard shuts OFF and the “CHECK ENGINE” or “CHK ENG” light is flashing, the out-
board cannot be restarted. A hazardous fuel condition may exist. Seek assistance to return to
port. See your Dealer.