Evinrude E-TEC 115, Оригинальное руководство пользователя

Страница: 50 / 90

48
Maintenance
SERVICE
ANTI-CORROSION ANODES
Your outboard is equipped with one or more
anodes that protect it from galvanic corrosion.
Disintegration of the anode is normal and in-
dicates it is working. Check each anode peri-
odically. Replace anodes smaller than 2/3
their original size. See your Dealer for re-
placements.
Galvanic corrosion destroys underwater met-
al parts and can occur in fresh or salt water;
however, salt, brackish, and polluted waters
will accelerate corrosion.
Metal-based antifouling paint on the boat or
outboard and the use of improperly installed
shore power in the area of your moored boat
will also accelerate corrosion.
NEVER paint the anode, its
fasteners, or its mounting surface. Paint-
ing will reduce its corrosion protection.
FLUSHING
Flush the outboard with fresh water following
use in brackish, salt or polluted water to
minimize the accumulation of scale and silt
deposits in cooling system passages. The
outboard can be flushed on the trailer or at
dockside. Place outboard in vertical (down)
position in a well ventilated area.
If you cannot store the out-
board in the recommended vertical posi-
tion, be sure the cooling system is
drained completely. Never place the
gearcase higher than the powerhead. Any
water remaining in the exhaust passages
can run into the cylinders and cause seri-
ous damage.
Using Lower Engine Cover Flushing
Port
1) Place the outboard in an area with good
drainage.
2) Connect garden hose to flushing port.
3) Turn on the water. It is not necessary to
run the engine for a good flushing.
4) Leave the outboard in vertical position long
enough to completely drain the power-
head.
Using Gearcase Flushing Device
1) Place the outboard in an area with good
drainage.
2) If equipped, temporarily cover the six aux-
iliary water inlet holes on the front of the
gearcase with heavy tape to insure enough
water travels to the powerhead from the
water intakes. Water can drain from auxil-
iary inlets, resulting in engine overheat.
Remember to uncover the holes after
flushing the engine.
Anti-corrosion anode DR5082
NOTICE
002024
NOTICE