Everpure MRS-200, Руководство по установке и запуску

Страница: 4 / 21

4
The storage tank stores water that has been produced by both the RO System and the filtered
water blend valve. It provides a water supply buffer enabling the system to provide reasonable
volumes of product water during high demand periods.
The product water re-pressurization pump develops and maintains the pressure required for
delivering the water from the storage tank to the connected equipment.
A unique cartridge monitor/alarm module has been included. This device can be set to provide
simultaneous water throughput and operating time indications over easily selectable ranges.
This monitor helps in determining cartridge change-out schedules.
Pre-Installation Checklist
1.
____
Can the unit be mounted within a reasonable distance of the water supply and
drain facilities?
2. ____
Are two 115 VAC GFIC protected receptacles available for connecting the 115
VAC/24 VAC transformer and product water re-pressurization pump?
3. ____
Is there adequate clearance and support to install the unit and permit access for
maintenance? The system will weigh approximately 175 pounds when the
storage tank is full.
4. ____
Does the inlet water supply meet the requirements listed below?
1

A minimum of 1.0 GPM at 50-100 psi pressure on a consistent basis

Less than 500 ppm Total Dissolved Solids

Less than 10 GPG of hardness

pH level between 7.0-9.0

Turbidity less than 1 NTU
1. Incoming water supplies that do not meet these requirements may need additional pre-treatment prior to the system.
System performance may be affected if requirements are not met, including system output production and cartridge
change-out frequency. Optional inlet booster pumps are available to increase supply water pressure and system
production.
System Installation
1. Locate the MRS-200 system in an area
that is convenient to the inlet water
supply and drain facilities, with access
for
routing the product water
tubing/piping to the equipment. Also
consider ease of service when selecting
a location.
2. Refer to Figure 1 for assembling the four
legs to the shelf. Insert each leg fully
with the two half sleeves provided.
Adjust the leveling bolt(s) as required
until the shelf is stable and level in all
directions.
Figure 1