Everlast POWER MTS 221STi, Руководство оператора

Страница: 21 / 72

21
Setup Guide and Component Identification Section 2
CONNECTIONS AND POLARITY
AC TIG ONLY! (GTAW - AC)
The foot pedal and the torch switch cannot be connected at the same time. The torch switch may remain attached to the
torch, but since they both use the control connection and serve a similar purpose only may be used at a time. Note: The
unit is supplied with a water - cooled torch and the diagram depicts proper connection for water - cooled torches. Do not use
this torch without a water cooler or torch damage will occur. To determine the gas line blow through the lines with com-
pressed air. Improper connection will result in no gas flow or water coming out of the torch head. For an air - cooled torch
alternative (all air - cooled torches handle 200 amps or less), contact Everlast for a full range of Everlast and NOVA torches.
TORCH -
CONTROL
PEDAL SWITCH
TO COOLER
FROM COOLER
GAS
WORK
(AC)
Note: Although fitted with a water cooler power plug
on the rear, the water cooler is optional and must
be purchased separately. The unit comes with a 26
series air - cooled TIG torch to support the 200 amp
capability of the welder. Any series and brand torch,
including any water - cooled torch may be fitted to
the unit, including water cooled A DINSE 35 con-
nector will have to be purchased from the torch
supplier in addition to the torch. However, to simpli-
fy this process, contact Everlast for a NOVA brand
torch product that is for a high - quality, flexible torch
specifically designed to fit your unit.