CUSTOMER SERVICE 1-888-707-1880 Dyaco Canada Inc.©2014
12
2
Connecting & Lower Swing Arms
Hardware Step 2
##99
. 5/16” × 15mm
Hex Head Bolt (2 pcs)
#101
. 5/16” × 1-1/4”
Hex Head Bolt (2 pcs)
#192
. 5/16”× 9T
Nyloc Nut (2 pcs)
#141
. 5/16” × 23 × 1.5T
Flat Washer (2 pcs)
#142
. 5/16” × 20 × 1.5T
Flat Washer (2 pcs)
#150
. 17mm
Wave Washer (4 pcs)
1. Slide two wave washers (
150
) onto each side of the Console Mast
axle. Slide the lower Handle Bars (
10
Left,
11
Right) onto the axles
and secure with the two Hex Head Bolts (
99
) and Flat Washers (
141
).
Do not force the lower Handle Bars onto the axle. They should slide on,
but you may need to jiggle them to get them lined up properly.
The lower Handle Bars have been previously installed at the factory so
they do fit properly.
2. Remove the tie that holds the Sleeve (
20
) in the rod end located at
the end of the right connecting arm (
9
) and line up the rod end with
the bracket at the bottom of the lower right Handle Bar (
11
). Slide
the Hex Head Bolt (
101
) through the bracket of the lower Handle Bar
and then through the rod end. Install the Flat Washer (
142
) and
Nyloc Nut (
192
) on the bolt and tighten as much as possible.
Repeat this step for the left side.
