80
Data Bit:
This field is the data bit at which you will be transferring. There are two settings for this option: 8
or 7.
Stop Bit:
This field is to set the stop bit for the RS232 connection. There are two different stop bits, 1 or 2.
Parity:
This field is to select the parity level at which you will be connected. You can choose between
None, Odd, or Even parity levels.
RS485
PTZ Protocol:
Select PTZ protocol
,
choose from the following protocols: Transparent, Pelco D, Pelco P,
Everfocus, or Samsung. (
NOTE: all cameras on the bus must use the same protocol
)
485 ID:
This is the ID used by the EKB500 to send commands to the DVR. On an RS485 connection, every
device (PTZ, DVR and controller) must be assigned a unique ID number between 0 and 127.
Baud Rate:
The speed used to transmit instructions or information through the RS485 port on the DVR.
Choose from the following speeds: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 BPS.
Data Bit:
The number of data bits used in a data packet or word. This can be set to 8 or 7.
Stop Bit:
This field is to set the number of stop bits indicating the end of a data packet. This can be set to 1
or 2.
Parity:
This selects the transmission error checking rule. Choose either None, Odd, or Even.
Control
IR Remote ID:
ID used by the remote control to select this DVR.
4.10.5
Misc.
Figure 4-37 System Menu – Firmware & Misc.
Firmware
Current Firmware Version:
Displays the current version.
