Installation
Guide
DS-7300HFI-S Series DVR
(V3.1.0)
Verify
Contents
Verify that the package contents are correct by checking the
items against the packing list.
Installation Guide
– DS-7300HFI-S Series DVR
1
Note:
Please contact your dealer for damaged or missing
items.
DVR
Pre
‐
Installation
The DS-7300HFI-S Series DVR is highly advanced
surveillance equipment that should be installed with care.
Please take into consideration the following precautionary
steps before installation of the DVR.
1.
Keep all liquids away from the DVR.
2.
Install the DVR in a well-ventilated and dust-free area.
3.
Ensure environmental conditions meet factory
specifications.
4.
Install a manufacturer recommended HDD.
DVR
Installation
During the installation of the DVR:
1.
Use brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When installing cables, ensure that the bend radius of the
cables are no less than five times than it’s’ diameter.
4.
Connect both the alarm and RS-485 cable.
5.
Allow at least 2cm (~0.75in) of space between racks
mounted devices.
6.
Ensure the DVR is grounded.
7.
Environmental temperature should be within the range of
-10ºC ~ 55ºC, 14ºF ~ 131ºF.
8.
Environmental humidity should be within the range of
10% ~ 90%.
Hard
Disk
Installation
Before installing a hard disk drive (HDD), please make sure
the power is disconnected from the DVR. A factory
recommended HDD should be used for this installation.
Tools Required:
Screwdriver.
To install a HDD on your DVR:
1.
Remove the cover from
the DVR by unfastening
the screws on the back
and side.
2.
Install the HDD in the
HDD rack using the
provided screws.
Fasten the screws on
the button to fix the
HDD.
3.
Connect the HDD to the
motherboard of the
DVR with the included
data cable.
4.
Connect the power
cable to the HDD.
5.
Re-install the cover of
the DVR and fasten
screws.
alarm shop
