Note:
The RS-485 PTZ control should be connected with
the T+ and T- pin on the RS-485 terminal block.
To connect a controller to the DVR:
1.
Disconnect
pluggable block
from the KB terminal block.
2.
Unfasten stop screws from the KB D+, D-
pluggable
block
, insert signal cables into slots and fasten stop
screws. Ensure signal cables are in tight.
Controller
Connection
3.
Connect Ta on controller to D+ on terminal block and Tb
on controller to D- on terminal block. Fasten stop screws.
4.
Connect
pluggable block
back into terminal block.
Note:
Make sure both the controller and DVR are grounded.
Installation Guide
- DS-7300HFI-S Series DVR
5
alarm shop
