Eventide BD500, Руководство оператора

Страница: 29 / 58

BD500 Broadcast Profanity Delay Appendix C Optional Remote Control Page 25
©Eventide Inc. 1995-1999
doc release 10
Full Delay This commands the unit into static mode at full delay. This command has no func-
tion in precision fixed delay mode.
Mute This command will mute the output audio while the closure exists. Note that the
unit will go into mute mode during this time so any button illumination or output
signal that reports on a particular mode will report mute mode instead of the previ-
ous mode, even if the BD500 is still performing the previous function. When mute is
no longer asserted the unit returns to the previous mode.
Station Break Insert mutes the outputs while save the audio into the buffer. When the buffer reaches 4
seconds this mode ends and the unit goes into ramp to zero mode.
These three special Remote Control features are supplied to allow maximum control with the minimum
number of buttons.
Ramp To Bypass performs a ramp to zero but when the unit reaches 0 delay it goes directly into
bypass.
Dump into Rebuild performs a dump and then goes into rebuild, regardless of the previous mode. This
operation has no affect in precision fixed delay mode. If the delay is already 0, then
the unit still goes into rebuild.
Wait and Exit/Rebuild If the unit is at zero delay, this command puts it into rebuild mode. If the unit is not
at zero delay, this command puts it into wait and exit mode.
Ramp to Zero/Rebuild If the unit is at zero delay, the unit is placed into rebuild mode. If the unit is not at
zero delay, the unit is put into ramp to zero.
Output Signals
The output signals may be configured to:
• OFF Off always high impedance (factory default)
• ON On always a closure to ground
• BYP Bypass closure to ground when bypassed, high impedance if in-line
• LIV Live closure to ground when in-line and at 0.00 delay
• WFS Wait For Safe closure to ground when doing wait for safe
• FUL Full Delay closure to ground when at full delay, high impedance when delay < full
• SAF Safe closure to ground when > than safe time, high impedance when < safe time
• WAE Wait And Exit closure to ground when doing wait and exit
• RT0 Ramp To Zero closure to ground when doing ramp to zero
• RBM Rebuild Mode closure to ground when in rebuild mode (doing rebuild, or at max). Note:
During sneeze or mute, the unit will still be rebuilding and will return to
rebuilding when mute or sneeze is released but this output signal will be off.
• REB Rebuild closure to ground when doing rebuild (not at max delay). Note: During sneeze
or mute, the unit will still be in rebuild mode and will return to rebuilding
when mute or sneeze is released but this output signal will be off.
• MUT Mute closure to ground when mute is being operated.
• DMP Dump closure to ground when dump is being operated.
• UNL Unlock closure to ground when AES/EBU is selected as an input but no digital audio
signal is present on the inputs. (requires optional digital audio card)
• SBI Station Break Insert closure to ground when a station break insert is in progress.
• RDY Ready closure to ground indicates the unit is in run-time with the rear panel inputs
ready to accept a command to adjust the delay length or go in or out of
BYPASS.
• ERR Error closure to ground indicates there is an error message in the Error Log
• AIO All Is OK closure to ground indicates there are no errors in the Error Log and the unit is
in run-time with the rear panel inputs are ready to accept a command to
adjust the delay length or go in or out of BYPASS.