Studio Pro 24
Installation and Operating Instructions
North American Model
Jan 2019
Page
13
of
17
Place the lid support bar onto the stud as shown.
Thread the “T” nut onto the stud. The collar on the T nut will fit into the
hole of the lid support bar and should be threaded on entirely. Tighten with
pliers or wrench.
Thread the acorn nut on to the stud and tighten with pliers or wrench.
Installation of the lid support bar is now complete. Now would be a good
time to double-check that the notch on the lid support bar is facing towards
the back of the kiln as shown. If it doesn’t look like the image above,
remove and remount properly.
Installation Complete
Kiln placement and installation is now complete. Please refer to the
operating instructions for proper placement of electrical receptacles, power
source disconnects and other electrical power requirements.
