Studio Pro 24
Installation and Operating Instructions
North American Model
Jan 2019
Page
12
of
17
Thread the “T” nut onto the stud. The collar on the T nut will fit into the
hole of the chamber safety bar and should be threaded on entirely. Tighten
with pliers or wrench.
Thread the acorn nut on to the stud and tighten with pliers or wrench.
Installation of the chamber safety bar is now complete. Now would be a
good time to double-check that the notch on the chamber safety bar is
facing towards the back of the kiln as shown. If it doesn’t look like the
image above, remove and remount properly.
Locate the Lid Support Bar.
You will note a mounting plate with stud on the right side of the kiln lid.
You will also notice a wireformed catch directly below it. These items are
involved with the installation of the Lid Support Bar. Remove the acorn and
T nuts.
Place the lid support bar through the wireform catch as shown.
