Studio Pro 24
Installation and Operating Instructions
North American Model
Jan 2019
Page
11
of
17
Chamber Safety Bar and Lid Support Bar Installation
Locate the included Chamber Safety and Lid Support Bars. You will note, as
indicated in the image above, that the Chamber Safety Bar is the longer
than the Lid Support Bar. Pay attention to the notched portion at the end of
each bar. These notches will face the back of the kiln when installed.
You will install the Chamber Safety Bar first.
You will note a mounting plate with stud on the left side of the kiln
chamber. You will also notice a wireformed catch directly below it. These
items are involved with the installation of the Chamber Safety Bar.
Remove the acorn nut and “T” nut from the kiln chamber mounting plate.
Place the chamber safety bar through the wireform catch and onto the
mounting plate stud as shown.
Please note that the notch in the chamber safety bar is to be
positioned so it faces the rear of the kiln as shown. Failure to
follow this instruction will not allow the chamber safety bar to
work as intended and will present a safety hazard.
