EURONOM Exotic Compact 10, Инструкция по установке и эксплуатации

Страница: 44 / 74

44
Brine medium
Dimensioning
The collector for earth / bedrock / groundwater / lake heat, etc. should be dimensioned according to
a computerised calculation program. Euronom has a dimensioning program and can assist with this
type of calculation.
Connection hoses
Brine medium hoses for the brine system are already installed at the factory and can be removed
from the tank on the right or left side.
The side plates are perforated at the outlets. Use pliers or a similar tool to cut off the metal blanks on
the desired side. Be careful because this can create sharp edges.
The brine hoses are marked with the text "Brine in" and "Brine out" with arrows showing the flow.
Condensation insulation
Since the brine system can become colder than 0
°
C, all pipes/connectors must be insulated to
prevent ice or condensation from forming.
Brine fluid
The brine medium should contain an antifreeze medium, e.g. bio ethanol, to maintain fluidity down
to temperatures of ‐ 15
°
C.
Collector hose
The collector hose, PEM 40 x 2.4 PN 6.3, is used as standard. Every metre of hosing holds about 1
litre of fluid.
Aerating
The earth heat collector should be installed in a manner that facilitates self ‐ aerating without any air
pockets. If this is not possible, aerating valves will have to be fitted to the highest points in the
collector. The level tank should be located at the highest point.
Fill coupling
Pre ‐ fabricated couplings, e.g. LK 520 Multifill 25, with integrated valves / dirt filters, are
recommended for quick installation in insulated houses.
Expansion vessel
The expansion vessel or level tank should be installed as high as possible on the incoming brine pipe (brine in).
Safety valve
A safety valve with opening pressure of max 3 bar should be installed.