E-Drive sur CF80 en Anglais
UCF-000R001-GB
F.M:08/14
p: 39/41
Before any work on the burner or burnt gases chimney, cut off gaz and electric main supply at their
own external feed valves.
GAS SUPPLY
The isolating valve must be fitted close to the appliance so it can be shut in
case of emergency
If several ovens are installed on the same supply, respect the aggregate of
the sections for the main supply pipe. If the length of the supply pipe is
great, increase its section accordingly.
The burner adjustment depends on the information contained on the nameplate.
NEVER EXCEED THIS POWER
ANY RESIZING WOULD CAUSE PERMANENT DAMAGES TO THE EXCHANGER
.
When all settings are completed, it is imperative to control the concentration of
CO and CO2 in the flue gases.
After fitting and testing of performances, combustion and safety of the block gas,
all of it's adjustment parts as well as the burner and the safety devices must be
sealed with a varnish : the adjusting parts which have been sealed must not be
touched.
The safety device governing the extraction of fumes MUST NOT be bypassed.
When first used, several successive ignitions can be necessary : If the ignition fails, the indicator light
comes on.
In that case, 1 minute later, try again to ignite the burner by pressing the reset button.
FOR SECURITY REASONS, THIS PERIOD CAN NOT BE SHORTENED IN ANY WAY.
A yearly chimney-sweeping is IMPERATIVE.
Risks linked with the GAS
